Parking Lock Emergency Release Cable, Removing And Installing: Removing
-- Pull the parking brake button to activate the electro-mechanical parking brake.
-- Remove the gearshift mechanism. Refer to SHIFT MECHANISM, REMOVING AND INSTALLING
-- Remove the noise insulation.
-- Remove the nuts -1 and 3- and free up the mount -2- for the emergency release.
-- Release the catches -arrows- and lower the bracket -4- for the emergency release.
Vehicles with a 6-cylinder TDI engine:
-- Remove the rear noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
Continuation for all vehicles
-- Loosen the heat shield for the tunnel and place on the driveshaft. Refer to OVERVIEW - HEAT SHIELDS .
-- Remove the bolts -arrows- and free up and remove the parking lock emergency release cable -1-.
Tip
A vehicle with a 6-cylinder TDI engine is shown.