Overview - Shift Mechanism

Selector mechanism in the vehicle interior

Fig 1: Exploded View Of Selector Mechanism

Courtesy of AUDI OF AMERICA, LLC

1. Shift Mechanism
   • Refer to Shift Mechanism, Removing and Installing  .
2. Selector Lever Transmission Range Display -Y5-
   • Refer to COMPONENT LOCATION OVERVIEW - CENTER CONSOLE LAMPS .
3. Selector Lever Handle, Upper Section
   • Refer to Selector Lever Handle, Removing and Installing  .
4. Bolt
   • not available separately
   • 3.2 Nm
5. Selector Lever Handle, Lower Section
   • Refer to Selector Lever Handle, Removing and Installing  .
6. Selector Lever Boot
   • Refer to SELECTOR LEVER BOOT ON SELECTOR LEVER HANDLE, DISCONNECTING AND ASSEMBLING 
7. Bolt
   • 8 Nm

Gearshift mechanism on transmission

Fig 2: Exploded View Of Gearshift Mechanism On Transmission

Courtesy of AUDI OF AMERICA, LLC

1. Drive Position Sensor -G676-
   • Refer to PARKING LOCK SOLENOID N486/DRIVE POSITION SENSOR G676, REMOVING AND INSTALLING  .
2. Shaft
   • For the parking lock
3. Bolt
   • M6 X 30
   • Always replace after removing
   • 3 Nm +90°
4. Parking Lock Solenoid -N486-
   • Electro-hydraulic part
   • Refer to PARKING LOCK SOLENOID N486/DRIVE POSITION SENSOR G676, REMOVING AND INSTALLING  .
5. Seal
   • Always replace after removing
6. Seal
   • For the parking lock shaft
   • Refer to Selector Shaft Seal, Replacing  .
7. Spring Pin
8. Lever
   • For the parking lock
   • Removing and installing. Refer to Selector Shaft Seal, Replacing  .
9. Cover
   • For the parking lock
   • With electric wiring harness
10. Bolt
    • M6 X 14
    • Always replace after removing
    • 3 Nm +45°
11. Bolt
    • M8 X 22
    • Always replace after removing
    • 8 Nm +60°
12. Alignment Pin
    • Quantity: 2
13. Bolt
    • M6 X 55
    • Always replace after removing
    • 3 Nm +180°
14. Bolt
    • M6 X 35
    • Always replace after removing
    • 3 Nm +90°