Transmission Fluid Auxiliary Hydraulic Pump - V552, Removing And Installing: Installing
-- Position the ATF pump -2- on the ATF motor -1-.
Conditions
- Pay attention to the alignment of the anti-twist mechanism -arrows-
-- Drive the ATF motor and ATF pump into the valve body using the Locking Pin : T10492 .
-- With the Locking Pin : T10492 mounted, install and tighten the bolts evenly all the way in.
-- Remove the Locking Pin :T10492 .
-- Install the Transmission Control Module -J217-. Refer to TRANSMISSION CONTROL MODULE J217, REMOVING AND INSTALLING .
-- Install the Mechatronic. Refer to Mechatronic, Removing and Installing .
-- After replacing the Transmission Fluid Auxiliary Hydraulic Pump -V552-, perform the calibration with the Vehicle diagnostic tester . Refer to DIAGNOSTIC ENTRY .