Transmission Control Module J217, Removing And Installing: Installing

-- Clean the threaded holes of residual oil and contamination.

-- Push the control module evenly on the valve body and tighten the bolts in the sequence -1- through -4-.

Fig 1: Transmission Control Module -J217- Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Check the protector of the ATF pump for correct seating.

Courtesy of AUDI OF AMERICA, LLC

-- Push in the sensor arm -1- on the ATF pump -2- by hand and tighten the bolts -arrow- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts to the tightening specification in the sequence -1- through -3-.

Fig 2: Sensor Arm Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the cover -1- for the sensor arm -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Hydraulic Pressure Sensor 2 -G546- and Hydraulic Pressure Sensor 1 -G545-.

Courtesy of AUDI OF AMERICA, LLC

Conditions

• Do not interchange the connectors. Make sure that the connection is correct as shown -1 and 2-.

-- Install the Mechatronic. Refer to Mechatronic, Removing and Installing  .