Hydraulic Pressure Sensor 1/2, G545/G546, Removing And Installing: Removing

-- Remove the transmission fluid pan. Refer to Transmission Fluid Pan, Removing and Installing  .

-- Release the catches -arrow A- of the connector for the Hydraulic Pressure Sensor 1 -G545- -1- and Hydraulic Pressure Sensor 2 -G546- -2- and disconnect from the Transmission Control Module -J217-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector using the Assembly Tool :T40305  .

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the bolts in the sequence -7- through -1-.

Fig 1: Hydraulic Pressure Sensor 1 And Hydraulic Pressure Sensor 2 - Loosening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove both hydraulic pressure sensors with retaining plate -arrow A- and wiring guide -arrow B-.