Overview - ATF Circuit
- O-Rings
- Always replace after removing
- ATF Pipe
- Always replace after removing
- O-Rings
- Always replace after removing
- ATF Cooler
- Refer to ATF Cooler, Removing and Installing .
- ATF Pipe Cover
- Depending on the version
- Bolt
- 8 Nm
- Bracket
- Bolt
- Always replace after removing
- Tightening Specification. Refer to Fig 2.
- Bolt
- Always replace after removing
- Tightening Specification. Refer to Fig 2.
- Coolant Hoses
- Bolt
- Always replace after removing
- Tightening Specification. Refer to Fig 2.
| Step | Bolts | Tightening Specification |
|---|---|---|
| 1 | -1- | Install all the way by hand |
| 2 | -1- | 3 Nm +90° |
| 3 | -2-, -3- | Install all the way by hand |
| 4 | -2-, -3- | 3 Nm +30° |