Camshaft Position Sensor -G40-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

All except Audi Q7/Q8:

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Audi Q7/Q8:

Remove the air filter housing. Refer to the appropriate service information

Continuation for All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3-.

-- Remove the bolt -1-, and remove the Camshaft Position Sensor -G40- -2-. (Shown with removed intake manifold.)