Charge Air Pressure Control Module -GX34-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
All except Audi A8/Q7/Q8:
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
Audi A8:
-- Free up the EVAP system hose -3- from the air duct pipe.
-- Remove the vacuum hose -4- without damaging it.
-- Press the release buttons on both sides and remove the secondary air injection pipe -5-.
-- Loosen the hose clamps -2 and 6- and remove the air duct hose.
Continuation for All Vehicles:
-- Slightly lift the locking spring -3- with a small screwdriver and remove from the ball pin control rod.
-- Disconnect the connector -2-.
-- Remove the bolts -arrows- and the Charge Air Pressure Control Module -GX34-.