Cam Adjustment Actuator, Removing And Installing: Installing

WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bring the Cam Adjustment Actuators into the Installed Position

Courtesy of AUDI OF AMERICA, LLC

Install in the reverse order of removal, while noting the following:

Check the O-rings for damage
The cam adjustment actuator pin must be brought into the installation position.

-- Press down the cam adjustment actuator pin -arrow- by hand.

The adjusting element pin must not be in the outward position.

-- Coat the O-rings with engine oil.

Install the air filter upper section. Refer to the appropriate service information

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .