Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission removed. Refer to TRANSMISSION, REMOVING (0CK, 0CJ, 0DP, 0DN) or TRANSMISSION, REMOVING (0D5) .
-- Insert the Counterhold - Flywheel :10 - 201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate if using unsuitable tools.
- Use an internal multi-point socket with a shaft that is at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts and remove the drive plate -1-.