Parking Lock, Removing And Installing: Installing

Shaft for the parking lock, installing

-- Guide the shaft from the parking lock -1- with the spring -2- in the hole in the clutch housing -arrow A-.

Fig 1: Install the Shaft for the Parking Lock -1-

Courtesy of AUDI OF AMERICA, LLC

-- Then push back the shaft -1- in the mount in the clutch housing -arrow B- and engage in the rest linkage -3-.

-- Drive in the sleeve -1- using the Extracting Tool - Thrust Piece :T40413/15  -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Drive in the seal -1- using the Extracting Tool - Guide Sleeve :T40413/14  -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Engage the spring -2- in the shaft for the parking lock -1-.

Courtesy of AUDI OF AMERICA, LLC

Parking lock, installing

-- Drive the parking lock -3- in the clutch housing. At the same time drive in the sleeves -2- alternating from side to side using the Valve Guide/Clutch Release Push Rod Seal Drift :10-206  -1- to the dimension -a-.

Fig 2: Parking Lock -3-, Installing

Courtesy of AUDI OF AMERICA, LLC

Conditions

• Dimension a = approximately 1.8 mm
• Drive in the center sleeve arrow flush with the parking lock 3.
• Pay attention to and if necessary hold the spring for the parking lock lever when driving in.

-- Tighten the bolts -1- for the parking lock -2-.

Fig 3: Parking Lock -2-, Removing

Courtesy of AUDI OF AMERICA, LLC