Overview - Output Shaft
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Internal Multi-Point Bolt
- Always replace after removing
- 300 Nm
- Inner Race
- Bearing H for output shaft roller bearing
- Spur Gear Unit Drive Wheel
- Spacer Sleeve
- 4th Gear
- 6th Gear
- Thrust Washer
- For 2nd gear assembly
- 2nd Gear Assembly
- Needle Bearing
- For 2nd gear assembly
- Inner Race/Needle Bearing
- For 2nd gear assembly
- Synchronization
- For the 2nd gear assembly / reverse gear
- Reverse Gear Assembly
- Needle Bearing
- For reverse gear assembly
- Inner Race/Needle Bearing
- For reverse gear assembly
- Thrust Washer
- For reverse gear assembly
- Bearing Bracket
- With reverse gear intermediate sprocket
- Thrust Washer
- For 1st Gear Assembly
- 1st Gear Assembly
- Needle Bearing
- For 1st Gear Assembly
- Inner Race/Needle Bearing
- For 1st Gear Assembly
- Synchronization
- For 1st Gear Assembly / 3rd Gear Assembly
- 3rd Gear Assembly
- Needle Bearing
- For 3rd gear assembly
- Output Shaft
- With splines for 5th and 7th gears
- Bearing Inner Race
- Bearing F for roller sleeve for output shaft
- Only for AWD vehicles
- Circlip
- Only for AWD vehicles