Overview - Input Shaft 1
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Small Needle Bearing
- Bearing "12"
- To the input shaft mounting 2 on the input shaft 1
- Large Needle Bearing
- Bearing "D"
- To the input shaft mounting 2 on the input shaft 1
- Sensor Wheel
- Always replace after removing
- Remove and install. Refer to Input Shaft, Disassembling and Assembling .
- Input Shaft 1
- With splines for the 1st and 3rd gear
- Refer to INPUT SHAFT 1, REMOVING AND INSTALLING
- Refer to INPUT SHAFT 1, DISASSEMBLING AND ASSEMBLING
- Thrust Washer
- For 5th gear assembly
- Needle Bearing
- For 5th gear assembly
- 5th Gear Assembly
- Synchronizer Ring
- For 5th gear assembly
- Do not interchange with the synchronizer ring for 7th gear
- Synchronizer Hub
- Removing and installing. Refer to INPUT SHAFT 1, DISASSEMBLING AND ASSEMBLING .
- Thrust Pieces
- Quantity: 3
- Locking Collar
- Synchronizer Ring
- For 7th gear assembly
- Do not interchange with the synchronizer ring for 5th gear
- 7th Gear Assembly
- Needle Bearing
- For 7th gear assembly
- Inner Race/Needle Bearing
- For 7th gear assembly
- Removing and installing. Refer to INPUT SHAFT 1, DISASSEMBLING AND ASSEMBLING .
- Thrust Washer
- For 7th gear assembly