Gear Set, Removing And Installing: Removing
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the transmission housing. Refer to Transmission Housing, Removing and Installing .
-- Prepare the 1/4 inch tool with Torx T30 and flexible extension as shown.
-- Remove the bolts -2- in the gear actuators -1-.
-- Remove the bolt for the Transmission Input Speed Sensor 1 -G632- -A- and remove the wire from the oil pan -B-.
-- Secure the Holding Strap : T40155A with Engine/Gearbox Support Shackle (2 pc.) : 10-222A/12 to the gear set and remove the transmission housing carefully using the Shop Crane : VAS 6100 .