Gear Actuator Module And Hydraulic Pressure Reservoir, Removing And Installing: Installing

-- Insert the gear actuator module and tighten the bolts in the sequence -1 through 6- hand-tight.

Fig 1: Gear Positioner Module Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Before installing the hydraulic pressure reservoir, coat the seals and oil filler hole with ATF.

-- Guide the hydraulic pressure reservoir evenly into the oil filler hole, and tighten the bolts -arrow- hand-tight.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the gear actuator and pressure reservoir to the tightening specification.

Bring the gear actuator into the basic setting

-- Press all gear actuators at the same time and turn to engage and align for the existing backlash.

Courtesy of AUDI OF AMERICA, LLC

-- Install the connector with the Assembly Tool :T40305  .

Courtesy of AUDI OF AMERICA, LLC

-- Install the gear set. Refer to GEAR SET, REMOVING AND INSTALLING .

-- Install the transmission fluid pan. Refer to Transmission Fluid Pan, Removing and Installing .

-- Install the transmission. Refer to Transmission, Installing .

-- After installing the transmission, perform the following functions: Refer to DIAGNOSTIC ENTRY .

• Distance Sensors, Calibration
• Parking Lock, Adaptation