Drive Motor Temperature Sensor -G712-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2025 Audi A4 allroad and 2025 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the transmission. Refer to TRANSMISSION, REMOVING .
-- Push the catches together -direction of the arrow A- and remove the cap -1-.
-- Remove the bolt -3- and loosen the locking tab -arrow B-.
-- Remove the panel -2- in the -direction of the arrow C-.
-- Release the flat terminal -3- using the Release Tool Set - Extraction Tool 7A :VAS 1978/7A from the connector housing -2-.
-- Loosen the wire Drive Motor Temperature Sensor -G712- from the bracket -4- -arrows-.
-- Remove the bolts -5- and remove the Drive Motor Temperature Sensor -G712- -1-.
CAUTION:
Risk of destroying the drive motor due to foreign objects.
- Cover the installation opening of the drive motor with a clean cloth.