Drive Plate, Removing And Installing: Removing
- The transmission is removed. Refer to TRANSMISSION, REMOVING .
-- Insert the Counterhold - Flywheel :10 - 201 to loosen the bolts.
CAUTION:
Risk of damaging the outer surface of the bearing flange at the drive plate if handled incorrectly.
- To loosen and tighten the drive plate bolt use the following tools.
- Use an internal multi-point socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate -1- and sensor wheel.