Engine Oil Cooler, Removing And Installing: Installing
Install in the reverse order of removal, while noting the following:
- Replacing the seals after removal.
Risk of contaminating the lubricating system and the bearing.
- Cover open engine components.
Risk of injuring the eyes from sealant residue.
- Wear protective eyewear.
-- Remove the sealant residue on the cylinder block and the engine oil cooler -1-, for example using a rotating plastic brush.
-- Clean any oil or grease off the sealing surfaces.
- Be sure to check the expiration date of the sealant.
-- Cut the tube nozzle at the front marking (nozzle diameter: about 2.5 mm).
There is a risk that the lubrication system could be blocked by excess sealant.
- Do not apply sealant bead thicker than indicated.
-- Insert the seals -2 and 3-.
-- Apply the sealant bead -1- to the clean sealing surface on the cylinder block.
- Sealant bead thickness: 3.0 mm
- Install the engine oil cooler within five minutes of applying the sealant.
- Used coolant cannot be used again.
-- Position the engine oil cooler and tighten the bolts.
Install in reverse order of removal. Note the following:
-- Check the oil level. Refer to ENGINE OIL .
There are different procedures depending on the model. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .