Part II

Part I. Refer to Part I .

Part III. Refer to Part III .

Fig 1: Exploded View Of Turbocharger, 3.0L Engine

Courtesy of AUDI OF AMERICA, LLC

1. Nut
   • After loosening, replace the stud bolt  . Stud Bolt
   • 20 Nm +30°
2. Tensioning Bracket
3. Seal
   • Replace after removing
4. Stud Bolt
   • After loosening, replace the nut  . Nut
   • 20 Nm
5. Tensioning Bracket
6. Nut
   • After loosening, replace the stud bolt  . Stud Bolt
   • 20 Nm +30°
7. Oil Return Line
   • Replace after removing
8. Clip
9. Air Duct Pipe
10. Bolt
    • Tightening specification. Refer to  . Bolt.
11. Seal
    • Replace after removing
12. Air Duct Pipe/Connections
    • There are different versions. Refer to the Electronic Parts Information (ETKA) for the allocation.
13. Bolt
    • Tightening specification. Refer to  . Bolt.
14. Seal
    • Replace after removing
15. Nut
    • Replace after removing
    • After loosening, replace the stud bolt  . Stud Bolt
    • Tightening Specifications:
      • Step 1: 15 Nm
      • Step 2: 30 Nm
      • Step 3: After finishing the procedures, tighten the nuts to 30 Nm
16. Turbocharger
    • Removing and Installing. Refer to TURBOCHARGER, REMOVING AND INSTALLING, 3.0L ENGINE .
17. Screw-Type Clamp
    • Replace after removing
    • 20 Nm
18. Seal
    • Replace after removing
19. Coupling
    • Replace after removing
20. Nut
    • Replace after removing
    • After loosening, replace the stud bolt  . Stud Bolt
    • Tightening Specifications:
      • Step 1: 15 Nm
      • Step 2: 30 Nm
      • Step 3: After finishing the procedures, tighten the nuts to 30 Nm
21. Seal
    • Replace after removing
22. Stud Bolt
    • After loosening, replace the nut  . Nut
    • 20 Nm