Charge Air System, Checking For Leaks: Procedure
-- Pay attention to the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Loosen the hose clamps -arrows- and remove the air duct pipe -1-.
-- Connect the Turbo System Tester Kit - Adapter 11 :V.A.G 1687/11 with the Turbo System Tester Kit - Adapter :V.A.G 1687/14 to the turbocharger.
-- Connect the hose -arrow- from the Turbo System Tester Kit :V.A.G 1687 to the adapter.
All additional procedures are described under: CHARGE AIR SYSTEM, CHECKING FOR LEAKS .
Assembling
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .