RIGHT SEAL, REPLACING, "quattro ultra", 0B0: Notes

Special tools and workshop equipment required 

• Puller - Unit Injector :T10055 
  Fig 1: Identifying Puller T10055

  Courtesy of AUDI OF AMERICA, LLC
• Rubber Sleeve Tool :3416/3 
  Fig 2: Rubber Sleeve Tool 3416/3

  Courtesy of AUDI OF AMERICA, LLC
• Circlip Pliers :VAS 5503A 
  Fig 3: Circlip Pliers (VAS 5503)

  Courtesy of AUDI OF AMERICA, LLC
• -1- Internal Puller :VAS 251 613 
  Fig 4: Identifying Kukko Puller

  Courtesy of AUDI OF AMERICA, LLC
• -4- Counter Support :VAS 251 623 
• Sealing Grease :G 052 128 A1 

• The rear final drive is removed. Refer to FINAL DRIVE, REMOVING AND INSTALLING .

-- Follow all general repair information. Refer to REPAIR INFORMATION .

-- Remove the circlip -4- using the Circlip Pliers :VAS 5503A  .

Courtesy of AUDI OF AMERICA, LLC

-- Remove the shim -3- and O-ring -2-.

-- Remove the right flange shaft using the Puller - Unit Injector :T10055  .

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the shaft seal -A- using the Puller - Crankshaft/Power Steering Seal :T20143/2  .

Courtesy of AUDI OF AMERICA, LLC