RIGHT SEAL, REPLACING, "quattro ultra", 09R: Notes

Special tools and workshop equipment required 

• Puller - Unit Injector :T10055 
  Fig 1: Identifying Puller T10055

  Courtesy of AUDI OF AMERICA, LLC
• Assembly Tool :T10356/2 
  Fig 2: Identifying Subframe Bushing Assembly Tool Kit

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - LH Flange Shaft Seal :3384 
  Fig 3: Seal Installer - LH Flange Shaft Seal 3384

  Courtesy of AUDI OF AMERICA, LLC
• Thrust Piece :T10233 
  Fig 4: Identifying Thrust Piece T10233

  Courtesy of AUDI OF AMERICA, LLC
• Circlip Pliers :VAS 5503A 
  Fig 5: Circlip Pliers (VAS 5503)

  Courtesy of AUDI OF AMERICA, LLC
• -1- Internal Puller :VAS 251 613 
  Fig 6: Identifying Kukko Puller

  Courtesy of AUDI OF AMERICA, LLC
• -4- Counter Support :VAS 251 623 
• Sealing Grease :G 052 128 A1 

• The rear final drive is removed. Refer to FINAL DRIVE, REMOVING AND INSTALLING .

-- Follow all general repair information. Refer to REPAIR INFORMATION .

-- Drive a hole centered into the cap -1- and pry out with a screwdriver.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the circlip -2- using the Circlip Pliers :VAS 5503A  .

-- Remove the shim -3-.

-- Remove the right flange shaft using the Puller - Unit Injector :T10055  .

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the shaft seal -A- using the Puller - Crankshaft/Power Steering Seal :T20143/2  .

Courtesy of AUDI OF AMERICA, LLC