LEFT SEAL, REPLACING, "quattro sport": Installing
Install in reverse order of removal. Note the following:
Install the right shaft seal.
-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.
-- Install the shaft seal all the way. Be careful not to bend it.
Installing the left shaft seal
-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.
-- Install the shaft seal all the way. Be careful not to bend it.
-- Insert the flange shaft.
Tip:
- If it is not possible to install the flange shaft all the way in by hand, then use a plastic mallet.
-- Tighten the new flange shaft bolt to the tightening specification ) Bolt.
-- Install the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
-- Check the ATF level in the rear final drive. Refer to ATF LEVEL, CHECKING .