Component Location Overview - Seals, Basic Final Drive, 0DB, 0D2 And 0G2

Fig 1: Exploded View Of Final Drive Seals (0DB, 0D2 AND 0G1 / 0G2)

Courtesy of AUDI OF AMERICA, LLC

1. Right Flange Shaft
   • Removing and Installing. Refer to RIGHT SEAL, REPLACING .
   • Final drive 0DB: the right and left flange shaft are identical
   • Final drive 0D2: -Arrow a- shaft diameter approximately 40 mm
2. Circlip
   • Always replace.
3. Right Protective Ring
   • Replacing. Refer to FLANGE SHAFT PROTECTIVE RING, REPLACING .
4. Right Seal
   • Replacing. Refer to RIGHT SEAL, REPLACING .
5. Rear Final Drive
   • Refer to FINAL DRIVE, REMOVING AND INSTALLING 
6. Left Flange Shaft
   • Removing and Installing. Refer to LEFT SEAL, REPLACING .
   • Final drive 0DB: the right and left flange shaft are identical
   • Final drive 0D2: -Arrow B- shaft diameter approximately 32 mm
7. Circlip
   • Always replace.
8. Left Protective Ring
   • Replacing. Refer to FLANGE SHAFT PROTECTIVE RING, REPLACING .
9. Left Seal
   • Replacing. Refer to LEFT SEAL, REPLACING .
10. Input Shaft Seal
    • Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
11. Protective Ring on Flange/Driveshaft
    • Replacing. Refer to FLANGE/DRIVESHAFT PROTECTIVE RING, REPLACING .
12. Flange/Driveshaft
    • Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING .
13. Circlip