All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Removing

-- Place the vehicle on a hoist.

• The ignition is off.

-- Place the Drip Tray under the rear final drive.

-- Disconnect the connector -1- from the All-Wheel Drive Pump -V415- -2-.

Fig 1: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the four bolts that connect the All-Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket :T10058  .

-- Carefully remove the All-Wheel Drive Pump -V415- -2-. Pay attention to the adapter  ) Adapter in the hydraulic pump while doing so.

• The adapter could fall out when removing the All-Wheel Drive Pump -V415-.
• Insert the adapter into the recesses in the hydraulic pump before installing the All-Wheel Drive Pump -V415-.