All-Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Installing

Fig 1: Assembling Hydraulic Pump

Courtesy of AUDI OF AMERICA, LLC

• The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to Figure.
• The adapter -B- is installed in the recesses in the hydraulic pump.
• A new O-ring -D- is on the All-Wheel Drive Pump -V415-.

-- Insert the All-Wheel Drive Pump -V415- with the coupling -C- into the adapter -B-.

-- Diagonally tighten the four bolts on the All-Wheel Drive Pump -V415- -2- to the tightening specification  ) Bolt.

Fig 2: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -1- to the All-Wheel Drive Pump -V415-.

-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, "quattro sport", 0D3, 0BX .