Right Flange Shaft, Removing And Installing: Removing

-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .

-- Remove the right drive axle heat shield. Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .

-- Place the Used Oil Collection and Extraction Unit :SMN372500  under the transmission.

-- Tighten the Slide Hammer Set : VW771  with Spindle : VW771/45  and Slide Hammer Set - Pin : VW771/43  to the flange shaft.

Courtesy of AUDI OF AMERICA, LLC

-- Remove flange shaft.