Final Drive Cover, Replacing: Notes

Special tools and workshop equipment required 

• Dial Gauge - 0-3mm : VAS 6080 
• Crankshaft Seal Installing Tool : VW204B 
• Caliper
• Caliper (4 pc.) : T40101 
• Counter-support
• Counter Support (Kukko 22/4) :VAS 251 625 
• Hot Air Gun
• Internal Puller
• Internal Puller (Kukko 21/89) :VAS 251 619 
• Ruler (2 pc.) :T40100 
• Measuring Set - End Gauge :VW 385/33 
• Dial Gauge
• Dial Gauge Extension
• Puller - Grease Cap :VW 637/2 
• Bearing Installer - Wheel Bearing :3345 
• Dial Indicator Holder :VW 387 
• Digital Depth Gauge :VAS 6087 

• When replacing the final drive cover the shim for the pre-loading differential must be determined again.
• This shim is located behind the outer race / angular contact ball bearing inside the final drive cover.