INPUT SHAFT SEAL, REPLACING, BASIC FINAL DRIVE, "quattro ultra", 0BD, 0D2, 0G2: Notes

Special tools and workshop equipment required 

• Puller - Multiple Use :VW 391 
  Fig 1: Puller - Multiple Use VW391

  Courtesy of AUDI OF AMERICA, LLC
• Slide Hammer Set - Adapter 40 :VW 771/40  from the Slide Hammer Set :VW 771 
  Fig 2: Identifying Slide Hammer Set

  Courtesy of AUDI OF AMERICA, LLC
• Puller - Unit Injector :T10055 
  Fig 3: Identifying Puller T10055

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Hollow Shaft :T10380 
  Fig 4: Identifying Thrust Piece - T10380

  Courtesy of AUDI OF AMERICA, LLC
• -2- Puller - Unit Injector - Adapter 2 :T10055/2 
• Guide Sleeve :T40222/1 
  Fig 5: Assembly Tool T40222

  Courtesy of AUDI OF AMERICA, LLC
• Inductive Heater :VAS 6414 
  Fig 6: Identifying Inductive Heater VAS 6414

  Courtesy of AUDI OF AMERICA, LLC
• or
• Commercially Available Hotplate with Digital Thermometer :VAS 6519 
  Fig 7: Identifying Digital Thermometer VAS 6519

  Courtesy of AUDI OF AMERICA, LLC
• Used Oil Collection and Extraction Unit :SMN372500 
  Fig 8: Identifying Used Oil Collection And Extraction Unit

  Courtesy of AUDI OF AMERICA, LLC
• Sealing Grease :G 052 128 A1 
• Two M 8 x 30 Bolts