PROTECTIVE RING ON FLANGE SHAFT, REPLACING, "quattro ultra"

Special tools and workshop equipment required 

• Press Plate :VW 401 
  Fig 1: Press Plate

  Courtesy of AUDI OF AMERICA, LLC
• Press Plate :VW 402 
  Fig 2: Press Plate (VW 402)

  Courtesy of AUDI OF AMERICA, LLC
• Press Piece - Multiple Use :VW 412 
  Fig 3: Identifying Press Piece - Multiple Use (VW 412)

  Courtesy of AUDI OF AMERICA, LLC
• -3- Separating Tool - 22 to 115mm, for example Splitter :VAS 251411 
  Fig 4: Commercially Available Puller Set

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Drive Flange :T10143 
  Fig 5: Seal Installer - Drive Flange T10143

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Clutch Housing :T40260 
  Fig 6: Seal Installer - Clutch Housing T40260

  Courtesy of AUDI OF AMERICA, LLC

• Flange shaft removed.

Fig 7: Identifying Separating Tool

Courtesy of AUDI OF AMERICA, LLC

• B -  Separating Tool, for example, Splitter :VAS251411 

Fig 8: Installing the protective ring -1- on the flange shaft

Courtesy of AUDI OF AMERICA, LLC

• Installation position: the larger outer diameter of the protective ring faces toward the flange.
• This image is a symbolic illustration. Use the Seal Installer - Drive Flange :T10143  .
• On the final drive "09R" use the Seal Installer - Clutch Housing :T40260  for the left flange shaft.