Left Seal, Replacing: Removing
-- Refer to TRANSMISSION, REMOVING .
-- Remove the left and right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Detach the flange shaft on the left side from the transmission slightly, but do not remove. Refer to Left Flange Shaft, Removing and Installing .
-- Remove the right flange shaft. Refer to Right Flange Shaft, Removing and Installing .
-- Remove the bolts -arrows- and the slowly and carefully remove the final drive cover.
-- At the same time, make sure that the differential does not fall out.
-- Carefully remove the differential -1- and lay it on a soft support.
-- Position the inner section of the Puller - Camshaft Seal :3240 flush with the outer section and lock the inner section using the knurled bolt.
-- Lubricate the puller threads, position, and using strong pressure insert the puller - camshaft seal as far as possible in the seal until the seal turns.
-- Turn the puller - camshaft seal further and at the same time pull until the seal is removed.
-- Tension the puller - camshaft seal on the flat side in a vise and remove the seal using pliers.
-- Check the seal in the transmission housing for damage and rework if necessary.
-- Clean the running and sealing surface.