Overview - Luggage Compartment Roll Cover
- Luggage Compartment Cover Motor 1 -V473-
- Equipped on some models
- Component location
- All except g-tron: behind the lock carrier trim panel
- g-tron: behind the left luggage compartment side trim panel
- Available only with ) Roll Cover Guide Rail
- Removing and Installing. Refer to LUGGAGE COMPARTMENT COVER MOTOR, REMOVING AND INSTALLING .
- Rivet
- Locking Pin
- Not available separately from the repair kit. Refer to the Electronic Parts Information (ETKA).
- Riveted with roll cover
- Roll Cover Catch
- Clipped into the guide rails
- Removing and Installing. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING, SEDAN .
- Clip
- Insert into the roll cover guide rail
- Remove any remaining clips in the D-pillar mounting points using the Omega Clip Tool :T40280 . To install, insert into the roll cover guide rail.
- Replace damaged or deformed clips
- Roll Cover Guide Rail
- Available only with ) Luggage Compartment Cover Motor 1 -V473-
- Removing and Installing. Refer to LUGGAGE COMPARTMENT COVER MOTOR, REMOVING AND INSTALLING .
- Bolt
- 4.5 Nm
- Bolt
- 2.5 Nm
- Luggage Compartment Roll Cover
- Frame
- For luggage compartment roll cover handle
- Not available separately from the repair kit. Refer to the Electronic Parts Information (ETKA).
- Replacing. Refer to LUGGAGE COMPARTMENT ROLL COVER HANDLE, REMOVING AND INSTALLING .
- Luggage Compartment Roll Cover Handle
- Not available separately from the repair kit. Refer to the Electronic Parts Information (ETKA).
- Replacing. Refer to LUGGAGE COMPARTMENT ROLL COVER HANDLE, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- 0.35 Nm
- Release Cable Bracket
- Release Cable Adjuster
- Nut
- Quantity: 3
- 2.5 Nm