Rear Thorax Airbag With Igniter, Removing And Installing: Installing
Install in the reverse order of removal, while noting the following:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Connect the connector -1- to the airbag igniter -arrow A-.
-- Press in the connector lock -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.
Conditions
- Make sure the wires are not pinched.
Pyrotechnical components can deploy unexpectedly.
A risk of injury is possible.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- If the battery was disconnected, perform the required steps after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Check and clear the DTC memory using the Vehicle diagnostic tester .