Airbag Control Module J234, Removing And Installing: Installing
Install in the reverse order of removal, while noting the following:
-- Replace any fasteners that are damaged.
-- Make sure the connectors audibly engage when connecting them.
-- Make sure the wires are not pinched.
-- Connect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Keep as far away as possible from the pyrotechnic component when switching the ignition on.
-- Switch the ignition on.
-- Check and clear the DTC memory using the Vehicle diagnostic tester .
-- Code the control module using the Vehicle diagnostic tester after replacing.