Radiator Module, Disassembling And Assembling

Radiator Module, Disassembling

-- Remove the radiator module. Refer to Radiator Module, Removing and Installing  .

-- Push in the left and right tabs -1- for the fan shroud in the -direction of the arrow A-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fan shroud -2- in the -direction of the arrow B- from the radiator.

-- Disconnect the air ducts -1- and -2-. For this, release the retainers -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Additionally release the lower retainers -3-. Push the air guide -1- and -2- apart.

Condition

• In order to be able to remove the condenser/gas cooler, the radiator blind -2- must first be pulled 15 mm out of the locking tab.

-- Push in the left and right retaining straps -1- for the radiator blind -2- in the -direction of the arrow A-.

Courtesy of AUDI OF AMERICA, LLC

-- Touch the outer radiator blind -2- and pull 15 mm upward out of the catch in the -direction of the arrow B-.

-- Push in the left and right retaining straps -1- for the condenser/gas cooler in the -direction of the arrow A- and remove the condenser/gas cooler -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Pull off the condenser/gas cooler -2- upward from the radiator in the -direction of the arrow B-.

-- Remove the radiator blind from the radiator.

Assemble the radiator module.

-- Bring the radiator blind -1- at the radiator -2- in installation position -arrows-. Do not click the radiator blind in place yet!

Courtesy of AUDI OF AMERICA, LLC

-- Install and lock the condenser/gas cooler -2-. Check for secure lock by pulling in the other direction.

Courtesy of AUDI OF AMERICA, LLC

-- Press the radiator blind -1- into the retainer outside at the frame.

-- Place the air guides -1- and -2- at the radiator and lock to one another -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Check the lower retainer -3- for secure fit.

-- Place the fan shroud on the radiator and lock.

-- Install the radiator module. Refer to Radiator Module, Removing and Installing  .

If the Radiator Blind Adjustment Motor -V711- was removed and installed:

-- Perform the "Radiator Blind Adjustment Motor, Adaptation" function using the Vehicle diagnostic tester . Refer to Diagnostic Entries .

Continuation

If the Radiator Blind Adjustment Motor -V711- was replaced:

-- Perform the "Radiator Blind Adjustment Motor, Replacing" function using the Vehicle diagnostic tester . Refer to Diagnostic Entries .