Can Bus Wires Repair Information
- Unshielded, twisted two-strand wiring -1- and -2- with a cross section of 0.13 mm2 or 0.35 mm2 is used as CAN-Bus wiring.
- Both CAN bus wires must be the same length.
- The repair of individual wire leads is not permitted.
- The repair of CAN bus wires must take place with the matching cross section and if possible with matching color coding. Refer to the Electronic Parts Information (ETKA) for the allocation.
- It must be ensured that the CAN cable length has a maximum variation of ±50 mm compared to its original length.
- There may be no section of wire -arrows- greater than dimension -a- = 100 mm without twisting the wiring.
- Wrap repair locations with yellow adhesive tape to mark a performed repair.
- The crimping of wires with connectors has to be performed in the same way.
- The repair locations -arrows- must not be on top of each other.
- The color coding for the CAN bus wires can be taken from the wiring diagram. Refer to the appropriate Wiring Diagram.
- The crimping of cables with connectors has to be performed in accordance with the repair information mentioned above.