Airbag And Belt TENSIONER Wire Repair Information

For repairs maximum of 2 repairs areas can be performed.
The crimp connectors must be shrunk.
Do not wrap the repair area back in the wiring harness.
Mark the repair location visible with yellow insulating tape.
Perform the repair a maximum 30 cm from the connector housing.
Lines to airbag and seat belt tensioner have a twisting with a routing length 20 mm ±5. The routing length must be maintained during the repair procedures.

When repairing wires must be of the same length. When twisting together wires -1- and -2-, length of lay of -a- =20 mm ±5 must be strictly observed.

Courtesy of AUDI OF AMERICA, LLC
There may be no section of wire -arrow- greater than dimension -b- = 100 mm without twisting the wiring.