Headlamp, Adjusting, Matrix Led Headlamp, CANADA: Notes

Required special tools, testing equipment

• Vehicle Diagnostic Tester
• Headlamp Adjusting Unit :VAS 621 001 

The headlamp must be adjusted/calibrated after the following procedures:

Condition

• Headlamp position was changed (removing and installing, loosening and tightening the screws)
• The Data Bus on Board Diagnostic Interface -J533- was replaced.
• The Vehicle Electrical System Control Module -J519- was replaced.
• A level control system sensor has been replaced.
• There is an entry in the DTC memory that indicates the matrix headlamp basic setting/calibration is missing.

Requirements

Condition

• Pay attention to the testing and adjustment requirements. Refer to HEADLAMP, ADJUSTING, GENERAL INFORMATION .