Spoiler, Removing And Installing: Removing
-- Raise the spoiler. Refer to the appropriate Service Information.
-- Remove the rear lid lower trim panel. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Push in the foam housing -1- in the rear lid.
-- Open the foam housing and remove the Rear Lid Closing Aid Motor -V382- -3-, then place down.
-- Remove the foam housing.
-- Reach through the opening and disconnect the connector -2-.
-- Free up the connector housing -1-.
-- Remove the left and right water drain hose -1- from the mount.
-- Remove the nuts -arrows- using the Body Socket:T40078 .
-- Loosen the cover retainers -3- using the scraper number 3 from the Scraper Set:VAS 6845 -1-.
-- Pry out the spoiler with the drive unit -2-.