Overview - Belt Pulley Side Sealing Flange
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Sealing Flange, Belt Pulley Side
- Removing and Installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .
- Seal
- For the belt pulley side crankshaft
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- Bolt
- Tightening Specifications and Sequence. Refer to Fig 2.
- Alignment Pin
- Is inserted in the belt pulley side sealing flange
- O-Ring
- Is inserted in the belt pulley side sealing flange
- Bolt
- 9 Nm
- Oil Dipstick Tube
- Alignment Pin
- Is inserted in the belt pulley side sealing flange
- O-Ring
- Replace after removing
Ribbed Belt Pulley Side Sealing Flange - Tightening Specifications and Sequence
-- Tighten the bolts -1 through 10- in steps as shown:
| Step | Tightening Specifications |
|---|---|
| 1. | Install all the way by hand |
| 2. | 9 Nm |