Vibration Damper, Removing And Installing, 3.0L Engine: Installing
WARNING: This page is about a different car, the 2024 Audi A8 Quattro, 2023 Audi A8 Quattro, and 2022 Audi A8 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Replace bolts that were tightened with an additional turn after removing them.
-- Position the vibration damper -1- on the crankshaft -2- and secure it with a new bolt. Pay attention to the alignment sleeve -arrow- at the same time.
-- Place the Adapter: T40330/4 with Counterholder: T40330/1 on the vibration damper and secure using the bolt -arrow- (23 Nm) to do so place the Spacer Sleeve: T40330/3 underneath.
-- Tighten the vibration damper bolt -1-.
-- Remove the bolt -arrow- and remove the counterholder.
-- Install the ribbed belt tensioner for the A/C compressor. Refer to RIBBED BELT TENSIONER FOR A/C COMPRESSOR, REMOVING AND INSTALLING, 3.0L ENGINE .
There are different procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .