FLANGE SHAFT PROTECTIVE RING, REPLACING, 0B0 AND 09R "quattro ultra"

Special tools and workshop equipment required 

• Press Plate: VW 401 
  Fig 1: Press Plate

  Courtesy of AUDI OF AMERICA, LLC
• Press Plate: VW 402 
  Fig 2: Press Plate VW402

  Courtesy of AUDI OF AMERICA, LLC
• Press Piece - Multiple Use: VW 412 
  Fig 3: Identifying Press Piece - Multiple Use VW412

  Courtesy of AUDI OF AMERICA, LLC
• -3- Separating Tool - 22 to 115mm, for example Splitter: VAS251411 
  Fig 4: Commercially Available Puller Set

  Courtesy of AUDI OF AMERICA, LLC
• Seal Installer - Drive Flange: T10143 

  Courtesy of AUDI OF AMERICA, LLC

• Seal Installer - Clutch Housing: T40260 

  Courtesy of AUDI OF AMERICA, LLC

• Flange shaft removed.

Removing the protective ring A from the flange shaft

Fig 5: Identifying Separating Tool

Courtesy of AUDI OF AMERICA, LLC

B -

Separating Tool, for example, Splitter: VAS251411 

Installing the protective ring 1 on the flange shaft

Fig 6: Installing the protective ring -1- on the flange shaft

Courtesy of AUDI OF AMERICA, LLC

• Installation position: the larger outer diameter of the protective ring faces toward the flange.
• This image is a symbolic illustration. Use the Seal Installer - Drive Flange: T10143  .
• On the final drive "09R" use the Seal Installer - Clutch Housing: T40260  for the left flange shaft.