Brake Caliper Piston, Removing And Installing: Installing
- Install the entire repair kit.
- Only use mineral spirits to clean the brakes.
- When a brake caliper piston or a piston cylinder are damaged, the brake caliper must be replaced.
-- Clean the surface of the brake caliper piston only with mineral spirits and let it dry.
-- Before inserting the seal, thinly coat it with Lithium Grease.
-- Insert the seal into the brake caliper and check for correct seating.
-- Place the protective cap -4- on the brake caliper piston -3-.
-- The protective cap -4- must sit correctly in the groove -arrow-.
-- Before inserting the piston and the seal, apply a thin coat of Lithium Grease.
-- Without tilting it, push the brake caliper piston -3- into the brake caliper -1- using constant pressure.
-- Press the protective cap -4- into the groove on the brake caliper. If necessary, use the Piston Resetting Tool: T10145 .
-- The protective cap must fit tightly in the groove -arrow-. If necessary, push down on it slightly with the Piston Resetting Tool: T10145 .
-- Repeat the work procedure on the next brake caliper piston.