Map Controlled Engine Cooling Thermostat -F265-, EMOVING AND INSTALLING: Removing

Preliminary work may be required depending on the model. Refer to MAP CONTROLLED ENGINE COOLING THERMOSTAT -F265-, EMOVING AND INSTALLING .

-- Remove the connector -1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Cylinder Block Coolant Valve -N545- -4- from the bracket and push it to the side.

-- Disconnect the connector -2- and free up the wires on the Map Controlled Engine Cooling Thermostat -F265-.

-- Remove the bolts -arrows- and remove the Map Controlled Engine Cooling Thermostat Map Controlled Engine Cooling Thermostat -F265-.

-- Dismount the seal -arrow- with the extractor lever -2-.

Courtesy of AUDI OF AMERICA, LLC