Engine Temperature Control Temperature Sensor -G694-, EMOVING AND INSTALLING, 2.9L ENGINE

Special tools and workshop equipment required 

• Socket:T10405 
  Fig 1: Identifying Socket T30

  Courtesy of AUDI OF AMERICA, LLC
• Straight needle nose pliers, long version, commercially available
• 45° angled needle nose pliers, long version, commercially available

Procedure 

Preliminary work may be required depending on the model. Refer to COOLANT PUMP/COOLANT THERMOSTAT ; Engine Temperature Control Sensor -G694-, emoving and Installing.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the engine cover and heat shield. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the bolts -1 and 2-, emove the coolant pipes from the turbochargers and push to the side.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Engine Temperature Control Sensor -G694- and disconnect the connector -1- using needle nose pliers.

• Replace the O-ring after removal.

-- Insert the engine coolant temperature sensor using needle nose pliers.

-- Install the right rear large coolant pipe. Refer to COOLANT PIPES, REMOVING AND INSTALLING .

-- Install the heat shield and engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Tightening Specifications

• Refer to OVERVIEW - COOLANT PUMP/COOLANT THERMOSTAT