Engine Coolant Temperature Sensor on Engine -G82-, EMOVING AND INSTALLING, 3.0L ENGINE
Procedure
Depending on the model, preliminary work may be required. Refer to ENGINE COOLANT TEMPERATURE SENSOR ON ENGINE OUTPUT -G82-, EMOVING AND INSTALLING ; Engine Coolant Temperature Sensor on Engine -G82-, emoving and Installing.
- The engine is cold.
-- To reduce the residual pressure in the cooling system, briefly open the coolant expansion tank cap -1- by releasing the retainer in direction of -arrow-.
-- Reinstall the cap until it engages.
-- Depending on the model, remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -1-.
-- Place a cleaning cloth underneath to catch any escaping coolant.
-- Remove the bolt -2- and remove the Engine Coolant Temperature Sensor on Engine -G82-.
TIP:
If an O-ring remains in the cylinder block, remove the O-ring with a wire.
- Replace the O-rings after removing them.
-- Insert the new engine coolant temperature sensor immediately so that as little coolant is lost as possible.
-- Depending on the model, install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .
There may be additional procedures depending on the model. Refer to ENGINE COOLANT TEMPERATURE SENSOR ON ENGINE OUTPUT -G82-, EMOVING AND INSTALLING ; Engine Coolant Temperature Sensor on Engine -G82-, emoving and Installing.
Tightening Specifications