Selector Lever Handle, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Check the clips -arrows- on the bottom of the selector lever handle upper section -1- are seated correctly, and if necessary press them in farther.
-- Attach the selector lever handle upper section to the selector lever handle lower section.
-- Clip in the selector lever boot on the Selector Lever Transmission Range Display -Y5-.
-- Check the selector mechanism. Refer to SHIFT MECHANISM, CHECKING .