Selector Lever Boot On Selector Lever Handle, Disconnecting And Assembling
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Separating
-- Remove the selector lever handle. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
-- Release the catches in direction of -arrows- and remove the selector lever boot -1- from the selector lever handle.
Assembling
-- Push the selector lever boot until it engages audibly on the selector lever handle.
- The selector lever boot can only be clipped into one position with the selector lever handle.
-- Install the selector lever handle. Refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .