Overview - MECHATRONIC
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Fluid Pan
- Removing and installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Replace after removing.
- M6 X 30
- Seal
- Replace after removing.
- Bolt
- Tightening specification and sequence. Refer to .
- Replace after removing.
- Bracket
- Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-
- Removing and installing. Refer to .
- Seals
- Replace after removing.
- Contact Element
- Bolt
- 3 Nm + 90°
- Replace after removing.
- M6 X 25
- O-Ring
- Replace after removing.
- Bleed Pipe
- Dust Ring
- Seals
- Replace after removing.
- Seal
- Replace after removing.
- Depending on the model
- For vehicles with Parking Lock Solenoid -N486-
- Mechatronic
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Mechatronic Bolts. Refer to
.
- M6 X 90
- Bolt
- 3 Nm + 90°
- Replace after removing.
- For vehicles with Parking Lock Solenoid -N486-
- M6 X 22
- Seal
- Replace after removing.
- Transmission Control Module -J217-
- Oil Pipe
- Depending on the model
- For vehicles with Parking Lock Solenoid -N486-
- Wiring Guide
- Replace after removing.
- Seals
- Replace after removing.
- ATF Pipe
- Replace after removing.
- Seals
- Replace after removing.
Transmission Fluid Pan - Tightening Specification and Sequence
-- Tighten the bolts in steps according to the specified sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 25- | Install all the way by hand |
| 2. | -1 through 25- | 3 Nm |
| 3. | -1 through 25- | 90° |