Overview - Assembly Mounts
WARNING: This page is about a different car, the 2024 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 70 Nm for FWD vehicles (M10x40 10.9)
- Tunnel Crossmember
- Removing and installing. Refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING .
- Bolt
- 20 Nm +90°
- Replace after removing
- Only remove if the transmission mount must be separated from the transmission support
- Stop
- For the transmission mount
- Transmission Mount
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Nut
- 20 Nm
- Only remove if the transmission mount must be separated from the transmission support
- Bolt
- 20 Nm
- Only remove if the transmission mount must be separated from the transmission support
- Transmission Support
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 40 Nm
- Nut
- 20 Nm